Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 93
PCI Hot Plug Interface Board, Remove all I/O expansion boards. See
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
2-76 Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide PCI Hot Plug Interface Board To remove the PCI Hot Plug interface board: 1. Remove the top access panel. See "Top Access Panel" earlier in this chapter. 2. Disconnect the cable securing the interface board to the system board . 3. Remove the extended SCSI dividers. See "Extended SCSI Dividers" earlier in this chapter. 4. Remove all I/O expansion boards. See "I/O Expansion Boards" earlier in this chapter. 5. Open the PCI expansion slot levers. 6. Pull the six push-pull fasteners to release the interface board . 7. Pull the interface board away from the sheet metal . 3 2 1 Figure 2-67. Removing the PCI Hot Plug interface board Reverse steps 1 through 7 to replace the PCI Hot Plug interface board.