Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 50
Redundant Front Processor Fan Assembly, Hot-Plug Front Processor Fan
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Removal and Replacement Procedures 2-33 Redundant Front Processor Fan Assembly To remove the redundant front processor fan assembly: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the hot-plug front processor fan assembly. See "Hot-Plug Front Processor Fan Assembly" earlier in this chapter. 3. Remove the two T-15 screws from the top of the redundant front processor fan assembly . 4. Pull the upper part of the assembly forward and unhook the bottom tab from the lower slot. 5. Unplug the fan power cable at the terminal connector. 6. Lift out the fan assembly and fan power cable. 3 2 1 4 Figure 2-28. Removing the redundant front processor fan assembly Reverse steps 1 through 6 to replace the redundant front processor fan assembly.