Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 228

18 Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide removable media devices configurations 2-15 location 2-15 location, illustrated 2-15 removing 2-17 removing, illustrated 2-17 replacing 2-17 removable media power connector, identified 4-4 removable media trim part number 1-3 removing 2-13 removing, illustrated 2-13 replacing 2-13 removal and replacement procedures 2-1 removing all power from system warning 2-2 removing server from rack 2-4 resource conflict, resolving 3-3 resource, Smart Array controller user guide 3-25 Resume POST message 3-9 return kit, part number 1-7 revision history table accessing 3-82 defined 3-82 table 3-82 where stored 3-82 right side access panel part number 1-3 removing 2-7 removing, illustrated 2-7 replacing 2-7 ROM is corrupted 3-85 ROMPaq disaster recovery 3-85 error recovery options 3-84 Firmware Upgrade Utility, accessing 3-5 interruption 3-85 Run System Configuration Utility F10 key POST message 3-9 S screws, part number 1-7 SCSI CD-ROM drives See CD-ROM drives SCSI devices POST messages 3-9 SCSI dividers part number 1-4 removing 2-70 removing, illustrated 2-70 replacing 2-70 SCSI hard drive test error codes table 3-41 SCSI hard drives See also hard drives removing 2-20 removing, illustrated 2-20 replacing 2-20 SCSI tape drive test error codes table 3-42 SCSI tape drives See tape drives SCSI, identified 4-2 SCSI/IDE CD-ROM test error codes table 3-42 SDRAM DIMM See memory security levels Caution, defined 3-65 Critical, defined 3-65 Repaired, defined 3-65 Status, defined 3-65 security, ASR-2 3-79 serial port connectors, identified 4-4 test error codes 3-40 serial test error codes table 3-40 server protecting from power fluctuations 2-5 removing from rack 2-4 specifications 5-2 warnings and precautions 2-5 weight 5-2 Server Health Logs 3-80 setting bus/core ratio switches caution 2-48 shipping materials, part number 1-7 signal cable kit, part number 1-7 single-rack installations warning 2-5 slide fillers, part number 1-3 slot X drive array replacement drive(s) detected OR previously failed drive(s) now operational 3-25 Smart Array controller cache specification 5-9 data transfer method 5-9 dimensions 5-9 heat dissipated 5-9 hot-plug guidelines 2-19 logical drives supported 5-9 maximum drives supported 5-9 part number 1-6 protocol 5-9 SCSI port connectors 5-9 specifications 5-9