Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 219
drive ID Y, Wide SCSI transfer
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 219 highlights
drive(s) disabled due to failure during expand 3-23 new logical drive(s) attachment detected 3-21 obsolete data found in array accelerator 3-23 physical drive position change(s) detected 3-20 ProLiant drive storage enclosure problem detected 3-25 ProLiant storage system not responding SCSI port (Y) 3-24 replacement drive(s) detected or previously failed drive(s) now 3-25 resuming logical drive expansion process 3-23 SCSI bus termination error 3-24 slot X drive array controller failure 3-26 slot X drive array drive failure 3-26 slot X drive array not configured 3-27 slot X drive array option ROM appears to conflict with an ISA card 3-22 slot X drive array option ROM is not programmed correctly 3-22 slot X drive array reports incorrect drive replacement 3-29 slot X drive array requires system ROM upgrade 3-22 slot X drive array SCSI drive(s) not responding 3-30 SMART SCSI hard drive detects imminent failure 3-20 snoop rules SRAM failure 3-12 soft firmware upgrade required 3-55 storage enclosure on SCSI bus X has a cabling error 3-55 storage enclosure on SCSI bus X indicated a door alert 3-56 storage enclosure on SCSI bus X indicated a power supply failure 3-56, 3-57 Index 9 storage enclosure on SCSI bus X indicated an overheated condition 3-56 storage enclosure on SCSI bus X indicated that the fan is degraded 3-57 storage enclosure on SCSI bus X indicated that the fan module is unplugged 3-57 storage enclosure on SCSI bus X is unsupported with its current firmware version 3-57 storage enclosure on SCSI bus X Wide SCSI transfer failed 3-58 swapped cables or configuration error detected 3-58, 3-59, 3-60, 3-61 system board failure 3-9 system board is unable to identify which slots the controllers are in 3-62 system fan failure detected 3-17 system fan not present 3-17 system options not set 3-9 system processor failed/mapped out 3-11 tag update rules SRAM failure 3-11 temperature alert 3-32 temperature violation detected 3-17 the controller can see the drives but the other controller can't 3-63 the controller can't see the drives but the other controller can 3-62 the redundant controllers installed are not the same model 3-62 the setup password is cleared 3-16 time & date not set 3-10 unable to communicate with drive on SCSI port X, drive ID Y 3-63 unable to retrieve identify controller data 3-63 unknown disable code 3-63 unrecoverable read error 3-63 unsupported processor detected system halted 3-9 voltage regulator module for processor X 3-11