Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 218

8 Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide low system battery 3-18 memory address error 3-10 memory detection failure 3-11 memory device failure 3-11 memory error 3-10 memory size error 3-10 memory type mismatch 3-10 mirror data miscompare 3-52 No configuration for accelerator board 3-52 nonfuntioning voltage regulator module 3-11 NVRAM configuration present, controller not detected 3-52 NVRAM has been reset 3-16 one or more drives is unable to support redundant controller operation 3-53 other controller indicates different cache size 3-53 other controller indicates different firmware version 3-53 other controller indicates different hardware model 3-53 parallel port address conflict detected 3-13 parallel port X address assignment conflict 3-13 PCI slots powered down 3-18 permanently disabled 3-46 power fault on processor bus X 3-12 power supply configuration error 3-18 power supply failure, power supply unplugged, or power supply fan failure 3-18 primary disk port address assignment conflict 3-23 primary fixed disk port assignment conflict 3-23 primary floppy port address assignment conflict 3-13 primary power supply failure 3-17 processor configuration invalid 3-10 processor PPM failed 3-11 processor PPM has lost redundancy 3-11 processor speeds must match for system operation 3-15 processor X missing terminator 3-14 RIS copies between drives do not match 3-53 ROM error 3-9 SCSI cable error detected 3-19 SCSI controller failure 3-19 SCSI port X drive ID X replaced on a good volume 3-55 SCSI port X drive ID Y is not stamped for monitoring 3-54 SCSI port X drive ID Y failed 3-53 SCSI port X drive ID Y frimware needs upgrading 3-53 SCSI port X drive ID Y has exceeded threshold(s) 3-54 SCSI port X drive ID Y may have a loose connection 3-54 SCSI port X drive ID Y RIS copy mismatch 3-54 SCSI port X drive ID Y SMART predictive failure errors 3-54 secondary controller or disk failure 3-30 secondary disk controller failure 3-30 secondary disk port address assignment conflict 3-23 serial port A address conflict detected 3-16 serial port address conflict detected 3-17 serial port B address conflict detected 3-16 server feature board 3-14 set configuration command issued 3-55 slot 1 drive array disk consistency initialization in progress 3-21 slot 1 drive array recovery needed 3-28 slot ID mismatch 3-10 slot X capacity expansion process is temporarily disabled 3-22 slot X drive array 3-19, 3-20, 3-22 array accelerator memory size change detected 3-20 critical drive firmware problem 3-23