Dell OptiPlex 7000 Small Form Factor Service Manual - Page 18
Installing the intrusion switch
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Steps 1. Disconnect the intrusion-switch cable from the connector on the system board. 2. Slide the intrusion switch and lift it away from the computer. Installing the intrusion switch Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the intrusion switch and provide a visual representation of the installation procedure. 18 Removing and installing components
Steps
1.
Disconnect the intrusion-switch cable from the connector on the system board.
2.
Slide the intrusion switch and lift it away from the computer.
Installing the intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the intrusion switch and provide a visual representation of the installation
procedure.
18
Removing and installing components