Dell OptiPlex 7000 Small Form Factor Service Manual - Page 55
Installing the processor fan and heat-sink assembly, Prerequisites, About this task, Steps
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
2. Loosen the four captive screws that secure the processor fan and heat-sink assembly to the system board. 3. Lift the processor fan and heat-sink assembly from the chassis. Installing the processor fan and heat-sink assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the processor fan and heat-sink assembly and provides a visual representation of the installation procedure. NOTE: If either the processor or the fan and heat-sink assembly is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved. Steps 1. Place the processor fan and heat-sink assembly on the system board and align the captive screws to the screw holes on the system board. 2. Tighten the four captive screws that secure the heat stink to the system board. 3. Connect the processor-fan cable to the system board. Removing and installing components 55