Dell OptiPlex 7000 Small Form Factor Service Manual - Page 23
Removing the 3.5-inch hard drive, Steps, Next steps, Prerequisites, About this task
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Steps 1. Align the slots on the 2.5-inch hard drive with the mounting points on the hard-drive carrier. 2. Pry the hard-drive carrier to align the mounting points on the hard-drive carrier with the slots on the 2.5-inch hard drive. 3. Snap the 2.5-inch hard drive onto the hard-drive carrier. 4. Align the tabs on the hard-drive carrier with the slots on the chassis and snap the hard-drive carrier onto the disk-drive cage. NOTE: Use the arrows seen on the caddy as guides to identify the tabs on the tray. 5. Connect the hard-drive data and power cables to the connectors on the hard drive. Next steps 1. Install the front bezel. 2. Install the side cover. 3. Follow the procedure in after working inside your computer. Removing the 3.5-inch hard drive Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. 3. Remove the front bezel. About this task The following images indicate the location of the 3.5-inch hard drive and provide a visual representation of the removal procedure. Removing and installing components 23