Dell OptiPlex 7000 Small Form Factor Service Manual - Page 76
Installing the system board
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Steps 1. Remove the screw (6-32) that secures the front I/O bracket to the chassis. 2. Rotate and remove the front I/O-bracket from the chassis 3. Disconnect all the cables that are connected to the system board. 4. Remove the four screws (#6-32) that secure the system board to the chassis. 5. Free the system board from the back I/O panel by sliding it towards the right and lift the system board out of the chassis. Installing the system board Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the system board and provides a visual representation of the installation procedure. 76 Removing and installing components