Dell OptiPlex 7000 Small Form Factor Service Manual - Page 39
Installing the SD-card reader
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
About this task The following images indicate the location of the SD-card reader and provide a visual representation of the removal procedure. Steps 1. Remove the power-supply cables from the routing guides on the SD-card reader bracket. 2. Remove the two screws (M3x5) that secure the SD-card bracket to the system board and the chassis. 3. Disconnect the SD-card reader from the connector on the system board. 4. Lift and remove the SD-card reader from the system. Installing the SD-card reader Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the SD-card reader and provide a visual representation of the installation procedure. Removing and installing components 39