Dell OptiPlex 7000 Small Form Factor Service Manual - Page 71
Installing the power-supply unit
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Steps 1. Disconnect the power-supply cables from the connectors on the system board. 2. Remove the power-supply cables from the routing guides on the chassis. 3. Remove the three screws (M6-32) that secure the power-supply unit to the chassis. 4. Slide and lift the power-supply unit off the chassis. Installing the power-supply unit Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the power-supply unit and provides a visual representation of the installation procedure. Removing and installing components 71
Steps
1.
Disconnect the power-supply cables from the connectors on the system board.
2.
Remove the power-supply cables from the routing guides on the chassis.
3.
Remove the three screws (M6-32) that secure the power-supply unit to the chassis.
4.
Slide and lift the power-supply unit off the chassis.
Installing the power-supply unit
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-supply unit and provides a visual representation of the installation
procedure.
Removing and installing components
71