Dell OptiPlex 7000 Small Form Factor Service Manual - Page 38
SD-card reader, Removing the SD-card reader
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Steps 1. Align and place the bay-support bracket on the slot on the chassis. 2. Replace the two (#6-32) screws that secures the bay-support bracket to the chassis. Next steps 1. Install the disk-drive cage. 2. Install the 3.5-inch hard-drive. 3. Install the 2.5-inch hard-drive. 4. Install the front bezel. 5. Install the side cover. 6. Follow the procedure in after working inside your computer. SD-card reader Removing the SD-card reader Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. 3. Remove the front bezel. 4. Remove the 2.5-inch hard-drive. 5. Remove the 3.5-inch hard-drive. 6. Remove the hard-drive and optical-drive cage. 38 Removing and installing components
Steps
1.
Align and place the bay-support bracket on the slot on the chassis.
2.
Replace the two (#6-32) screws that secures the bay-support bracket to the chassis.
Next steps
1.
Install the
disk-drive cage
.
2.
Install the
3.5-inch hard-drive
.
3.
Install the
2.5-inch hard-drive
.
4.
Install the
front bezel
.
5.
Install the
side cover
.
6.
Follow the procedure in
after working inside your computer
.
SD-card reader
Removing the SD-card reader
Prerequisites
1.
Follow the procedure in
before working inside your computer
.
2.
Remove the
side cover
.
3.
Remove the
front bezel
.
4.
Remove the
2.5-inch hard-drive
.
5.
Remove the
3.5-inch hard-drive
.
6.
Remove the
hard-drive and optical-drive cage
.
38
Removing and installing components