Dell OptiPlex 7000 Small Form Factor Service Manual - Page 94
Passwords, Table 23. Security continued
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Table 23. Security (continued) Options Chassis Intrusion Clear Intrusion Warning SMM Security Mitigation Data Wipe on Next Boot Start Data Wipe Absolute Absolute UEFI Boot Path Security UEFI Boot Path Security SafeShutter SafeShutter Passwords This section provides details on password settings. 94 BIOS setup Description This field controls the chassis intrusion feature ● Disabled - Will not report intrusions during POST ● Enabled - Will report intrusions during POST ● On-silent - Detects intrusions but does not display any detected intrusions during POST (Selected by default) This section contains a toggle switch to enable/disable warnings on intrusion (OFF by default). This section allows the user to enable or disable UEFI SMM security Mitigation protections (ON by default). This section contains toggle switch which when enabled ensures that the BIOS will queue up a data wipe cycle for storage device(s) connected to the system board on the next reboot (OFF by default). This section lets the user enable, disable or permanently disable the BIOS module interface of the optional Absolute Persistence Module service from Absolute Software. The options available are as follows: ● Enable Absolute - Enables Absolute Persistence and load the firmware Persistence Module (Selected by default) ● Disable Absolute - Disables Absolute Persistence. The firmware Persistence Module is not installed. ● Permanently Disable Absolute - Permanently disables Absolute Persistence module interface from further use. This section lets the user control whether the system will prompt the user to enter the admin password(if set) when booting to a UEFI booth path device from F12 boot menu. The options available are as below: ● Never ● Always ● Always Except Internal HDD (Selected by default) ● Always Except Internal HDD&PXE This section allows the user to choose between dynamic and manual shutter control: ● Dynamic Shutter - Camera shutter will automatically open when user grants application permission and close when permission ends. Can be disabled by using the F9 camera mute key(LED on). This is the default selected option. ● Manual Shutter Control - Shutter opens when F9 key is pressed(LED off) and closes when F9 key is pressed(LED on)