Dell OptiPlex 7000 Small Form Factor Service Manual - Page 35
Installing the M.2 2280 PCIe solid-state drive
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
3. Remove the front bezel. 4. Remove the 2.5-inch hard-drive. 5. Remove the 3.5-inch hard-drive. 6. Remove the hard-drive and optical-drive bracket. About this task The following images indicate the location of the M.2 2280 PCIe solid-state drive and provide a visual representation of the removal procedure. Steps 1. Remove the (M2x3) screw that secures the 2280 solid-state drive to the system board. 2. Slide and lift the 2280 solid-state drive from the M.2 card slot on the system board. Installing the M.2 2280 PCIe solid-state drive Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicates the location of the M.2 2280 PCIe solid-state drive and provide a visual representation of the installation procedure. Removing and installing components 35