Dell OptiPlex 7000 Small Form Factor Service Manual - Page 33
Solid-state drive, Removing the M.2 2230 PCIe solid-state drive
View all Dell OptiPlex 7000 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Next steps 1. Install the disk-drive cage. 2. Install the 3.5-inch hard-drive. 3. Install the 2.5-inch hard-drive. 4. Install the front bezel. 5. Install the side cover. 6. Follow the procedure in after working inside your computer. Solid-state drive Removing the M.2 2230 PCIe solid-state drive Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. 3. Remove the front bezel. 4. Remove the 2.5-inch hard-drive. 5. Remove the 3.5-inch hard-drive. 6. Remove the hard-drive and optical-drive cage. About this task The following images indicate the location of the M.2 2230 PCIe solid-state drive and provide a visual representation of the removal procedure. Steps 1. Remove the single (M2x3) screw that secures the solid-state drive to the system board. 2. Slide and lift the 2230 solid-state drive from the M.2 card slot on the system board. Removing and installing components 33