Dell PowerEdge R510 Hardware Owner's Manual - Page 111
Installing a Redundant Power Supply
View all Dell PowerEdge R510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Figure 3-17. Removing and Installing a Redundant Power Supply 1 2 1 power supply 3 velcro strap 4 3 2 power supply handle 4 release latch Installing a Redundant Power Supply 1 Verify that both power supplies are of the same type and have the same maximum output power. NOTE: The maximum output power (shown in watts) is listed on the power supply label. 2 Slide the new power supply into the chassis until the power supply is fully seated and the release latch snaps into place. See Figure 3-17. NOTE: If you unlatched the cable management arm in step 2 of the previous procedure, relatch it. For information about the cable management arm, see the system's rack documentation. 3 Connect the power cable to the power supply and plug the cable into a power outlet. CAUTION: When connecting the power cable, secure the cable with the Velcro strap. Installing System Components 111