Dell PowerEdge R510 Hardware Owner's Manual - Page 91
Installing the Cooling Shroud, Hard Drives, Removing a Hard-Drive Blank
View all Dell PowerEdge R510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Installing the Cooling Shroud 1 Align the shroud using the center of the numbered fan bays as a guide. 2 Press the cooling shroud down into the chassis. 3 Close the system. See "Closing the System" on page 89. 4 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals. Hard Drives Your system supports 3.5-inch or 2.5-inch (SAS or SATA) hard drives in 3.5-inch hot-swap hard drive carrier or cabled internal drives. Depending on your chassis, the hard drives are installed internally or at the front of the system (see Figure 3-1). Front-mounted hard drives are connected to a SAS backplane through hard-drive carriers and can be configured as hotswappable. NOTE: Systems with cabled hard drives support up to four 3.5-inch SAS or SATA hard drives. Removing a Hard-Drive Blank CAUTION: To maintain proper system cooling, all empty hard-drive bays must have drive blanks installed. NOTE: This section is applicable to systems with hot-swappable hard drives only. 1 Remove the front bezel. See "Removing the Front Bezel" on page 86. 2 Grasp the front of the hard-drive blank, press the release lever on the right side, and slide the blank out until it is free of the drive bay. See Figure 3-7. Installing System Components 91