Dell PowerEdge R510 Hardware Owner's Manual - Page 140
Rotate the processor shield upward and out of the way. See
View all Dell PowerEdge R510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Figure 3-26. Installing and Removing the Heat Sink 1 2 1 heat sink heat-sink 2 retention screws (4) 10 Rotate the processor shield upward and out of the way. See Figure 3-27. 11 Lift the processor out of the socket and leave the release lever up so that the socket is ready for the new processor. CAUTION: Be careful not to bend any of the pins on the ZIF socket when removing the processor. Bending the pins can permanently damage the system board. NOTE: In single-processor configurations, a processor must be installed in socket CPU1. Install the blank in socket CPU2 only. 140 Installing System Components
140
Installing System Components
Figure 3-26.
Installing and Removing the Heat Sink
10
Rotate the processor shield upward and out of the way. See Figure 3-27.
11
Lift the processor out of the socket and leave the release lever up so that
the socket is ready for the new processor.
CAUTION:
Be careful not to bend any of the pins on the ZIF socket when removing
the processor. Bending the pins can permanently damage the system board.
NOTE:
In single-processor configurations, a processor must be installed in socket
CPU1. Install the blank in socket CPU2 only.
1
heat sink heat-sink
2
retention screws (4)
2
1