Dell PowerEdge R510 Hardware Owner's Manual - Page 114
Installing a Non-Redundant Power Supply, System Memory
View all Dell PowerEdge R510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
1 bracket 3 power supply 5 optical drive power cable 7 SATA power cable 2 screws (2) 4 power cable 8 pins 6 power cable 24 pins Installing a Non-Redundant Power Supply NOTE: This section is applicable to systems with cabled hard drives only. 1 Open the system. See "Opening the System" on page 87. 2 Slide the new power supply into the chassis until the power supply is fully seated, install a bracket at the back of the power supply, and tighten the screws to secure the power supply with the chassis. See Figure 3-18. 3 Connect the power cable to the power supply. 4 Connect all the power cables to the system board, hard drive(s), and optical drive. 5 Plug the cable into a power outlet. 6 Replace the system cover. See "Closing the System" on page 89. 7 Turn on the system and attached peripherals. System Memory Your system supports DDR3 registered DIMMs (RDIMMs) or unbuffered ECC DIMMs (UDIMMs). Single and dual-rank DIMMs can be 1067- or 1333-MHz, and quad-rank DIMMs can be 1067-MHz. The system contains eight memory sockets split into two sets of four sockets, one set per processor. Each four-socket set is organized into three channels. Two DIMMs for channel 0 and a single DIMM for channel 1 and 2. The first socket of each channel is marked with white release levers. 114 Installing System Components