Dell PowerEdge R510 Hardware Owner's Manual - Page 165
System Board, Removing the System Board
View all Dell PowerEdge R510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
System Board Removing the System Board CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may be prompted to create a recovery key during program or system setup. Be sure to create and safely store this recovery key. If you replace this system board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on your hard drives. 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 87. 3 Remove the cooling shroud. See "Removing the Cooling Shroud" on page 90. 4 Remove the power supplies. See "Removing a Redundant Power Supply" on page 110 or "Removing a Non-Redundant Power Supply" on page 112. 5 Remove all expansion cards and, if applicable, the storage controller card. See "Removing an Expansion Card" on page 126 and "Removing the Storage Controller Card" on page 129. 6 Remove the expansion-card riser. See "Removing an Expansion-Card Riser" on page 127. 7 Remove the heat sinks, processors and heat-sink blanks. See "Removing a Processor" on page 138. 8 If installed, remove the iDRAC6 Enterprise card. See "Removing an iDRAC6 Enterprise Card" on page 136. 9 If installed, remove the iDRAC6 Express card. See "Removing an iDRAC6 Express Card" on page 133. 10 Disconnect all cables from the system board. Installing System Components 165