Dell PowerEdge R510 Hardware Owner's Manual - Page 139
WARNING, CAUTION, Gently lift the heat sink off of the processor and set the heat sink aside
View all Dell PowerEdge R510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
3 Open the system. See "Opening the System" on page 87. 4 Remove the cooling shroud. See "Removing the Cooling Shroud" on page 90. WARNING: The heat sink and processor are hot to touch for some time after the system has been powered down. Allow the heat sink and processor to cool before handling them. CAUTION: Never remove the heat sink from a processor unless you intend to remove the processor. The heat sink is necessary to maintain proper thermal conditions. 5 Using a #2 Phillips screwdriver, loosen one of the heat-sink retention screws. See Figure 3-26. 6 Wait 30 seconds for the heat sink to loosen from the processor. 7 Loosen the other three heat-sink retention screws. 8 Gently lift the heat sink off of the processor and set the heat sink aside with thermal grease side facing up. CAUTION: The processor is held in its socket under strong pressure. Be aware that the release lever can spring up suddenly if not firmly grasped. 9 Position your thumb firmly over the processor socket-release lever and release the lever from the locked position. Rotate the lever 90 degrees upward until the processor is released from the socket. See Figure 3-27. Installing System Components 139