Dell PowerStore 5000X EMC PowerStore Installation and Service Guide - Page 94
Remove a faulted drive, Installing a drive
View all Dell PowerStore 5000X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Remove a faulted drive Steps 1. Locate the drive with the blinking amber LED fault light. 2. Push down the orange button to release the latch. 3. Remove the drive from the slot. Figure 122. Removing a drive 4. Place the drive on a static-free surface. Installing a drive About this task NOTE: If you are installing multiple drives in a system that is powered up, wait at least 10 seconds before sliding the next drive into position. Steps 1. Align the drive with the guides in the slot. 2. With the latch fully opened, gently push the drive into the slot. The latch begins to rotate downward when it meets the enclosure. 3. Push the orange button until the drive is fully seated in the slot. 4. Push the latch down until it locks into place. 94 Expansion enclosure service procedures