HP 1200 Service Manual - Page 109
Motor, Remove the two screws callout 2 from the motor and lift
UPC - 637836445790
View all HP 1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Note Motor You might find it easier to remove the ECU pan (see page 120) before you remove the motor. Remove the left side, back, and right side covers (see pages 80 through 86). 1 Remove the fuser assembly (see page 101). 2 Disconnect the motor cable connector (callout 1) on the side of the motor. 3 Remove the two screws (callout 2) from the motor and lift the motor out of the printer. 2 21 Figure 51. Removing the motor To reinstall Make sure that the motor is in the correct position. The connector should face the inside of the printer. EN Internal assemblies 107
EN
Internal assemblies
107
Motor
Note
You might find it easier to remove the ECU pan (see page 120) before
you remove the motor.
Remove the left side, back, and right side covers (see pages 80
through 86).
1
Remove the fuser assembly (see page 101).
2
Disconnect the motor cable connector (callout 1) on the side of
the motor.
3
Remove the two screws (callout 2) from the motor and lift the
motor out of the printer.
Figure 51.
Removing the motor
To reinstall
Make sure that the motor is in the correct position. The connector
should face the inside of the printer.
2
2
2
1