HP 1200 Service Manual - Page 120

Note Paper lift plate assembly 1 Remove the left side, back, right side, and top covers (see pages 80 through 87). 2 Remove the front cover, toner cartridge door, and front guide assembly (see pages 89 through 95). 3 Remove the right plate assembly (see page 112), the pickup assembly (see page 114), and the pickup roller shaft (see page 117). 4 Grasp the large plastic tabs (callout 1) on each side of the paper lift plate and rotate it forward. Do not pull on the paper guides. Make sure you do not misplace the two large springs (callout 2) that are under the lift plate or the small spring that is under the separation pad arm. 5 Lift the paper lift plate straight up and out of the bushings (callout 3). 21 2 23 Figure 62. Removing the paper lift plate assembly To reinstall Make sure that the vertical paper sensor (the narrow black plastic piece to the left of the separation pad arm) is in an upright position and that the lift plate springs are positioned properly. 118 Chapter 5 - Removal and replacement EN