HP 450c HP DesignJet 430, 450C, and 455CA Printer - User's Guide - Page 23
To do this, first hold the module at an angle, and then gradually push
View all HP 450c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
SETUP 1 Setting up your printer Task 2: (Optional) Install a memory expansion module CAUTION Before handling a memory module, either put on a grounding wrist strap and attach the end to the metal chassis of the printer, or touch the outer metal surface of the printer with your hand. Otherwise, static electricity from your body could damage the memory module. 3 Take the memory module out of its bag, holding the module only by the edges. 4 With the module's small notch on the left and the metallic edge away from you, load the module into the slot nearest to you. (The other slot is not for memory modules.) To do this, first hold the module at an angle, and then gradually push it back until it clicks into place vertically. Notch 2 1 Slot nearest to you 5 Replace the cover plate and screws. Push until it clicks into place 1-7