HP A4500A Hardware Manual - rp24xx, Customer Viewable - Page 201
Insert the Server into the Rack
View all HP A4500A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 201 highlights
Insert the Server into the Rack Insert the Server into the Rack rp24xx servers are available in three configurations: rack-mounted, stacked, or stand-alone. Access to servers mounted in an HP-supported rack is covered in this section. To return the server into the rack, perform the following steps: Step 1. Push and hold each rail clip in to unlock the rail from the fully extended position. Slowly push server chassis completely into the rack. Step 2. Replace the four T-25 screws on each side of the server that fasten it to the rack. Step 3. Attach the front Bezel. The following graphic shows the server extended and indicates the rail clip location. ccrr014 Chapter 297
Chapter
Insert the Server into the Rack
297
Insert the Server into the Rack
rp24xx servers are available in three configurations: rack-mounted, stacked, or stand-alone. Access to servers
mounted in an HP-supported rack is covered in this section.
To return the server into the rack, perform the following steps:
Step 1.
Push and hold each rail clip in to unlock the rail from the fully extended position. Slowly push
server chassis completely into the rack.
Step 2.
Replace the four T-25 screws on each side of the server that fasten it to the rack.
Step 3.
Attach the front Bezel.
The following graphic shows the server extended and indicates the rail clip location.
ccrr014