HP A4500A Hardware Manual - rp24xx, Customer Viewable - Page 82
Step 1. - plastic parts
View all HP A4500A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Server Slide Rail Installation The following illustration shows rail parts only. Plastic parts bags, plastic end caps, and the cable management device is not shown: NOTE This illustration shows non-E-series HP cabinet columns The following procedures list the steps required to install a stand-alone server in a cabinet. Step 1. Attach rear slide mounts to the outer rails using M4 x 0.7mm screws. Do not fully tighten screws. Allow the rear slide mount to move along slot in the outer rail. 90 Chapter
Chapter
Server Slide Rail Installation
90
The following illustration shows rail parts only. Plastic parts bags, plastic end caps, and the cable
management device is not shown:
NOTE
This illustration shows non-E-series HP cabinet columns
The following procedures list the steps required to install a stand-alone server in a cabinet.
Step 1.
Attach rear slide mounts to the outer rails using M4 x 0.7mm screws. Do not fully tighten screws.
Allow the rear slide mount to move along slot in the outer rail.