HP Color LaserJet CM2320 HP Color LaserJet CM2320 MFP - User Guide - Page 218
Control-panel messages, continued, Load Tray # <TYPE> <SIZE>, Press OK
View all HP Color LaserJet CM2320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 218 highlights
Table 15-1 Control-panel messages (continued) Control panel message Description Recommended action control panel instructions. See Clear jams on page 207. Load paper Out of paper in all available trays. Load paper in trays. Load Tray # , Press OK to Device is processing job, but a matching tray Press OK to use existing available media. use available media is empty. Load Tray 1, / Cleaning Load a clean blank sheet of paper. Cleaning Press OK to begin the cleaning procedures. mode, OK to start mode paper prompt. Manual duplex Load tray #, Press OK Manual duplex mode. "#" is the tray number Load paper in the correct tray in the correct where the first half of the job printed. orientation. Manual feed , Press OK to Print Manual Feed mode. use available media Load paper into tray 1. Memory is low Try again later The product does not have enough memory Wait until the current job is finished before to start a new job. starting a new job. Turn power off and then on to clear memory. Memory is low. Press OK The product memory has been almost completely filled. Allow the product to finish the job, or press Setup to cancel the job. Turn power off and then on to clear memory. Memory low Only 1 copy made Press OK The product does not have enough memory Break the job into smaller jobs that contain to continue to complete the collated copy job. fewer pages. Turn power off and then on to clear memory. Misprint, Press OK Feed delay misprint. Verify that the media was inserted far enough into the input tray. In tray 2, verify that the paper-length guide is in the correct position for the media size that you are using. Reload paper. Non-HP supply Installed A new supply has been installed that is not made by HP. This message is appears for several seconds, and then the product returns to the Ready state. If you believe you purchased an HP supply, please call the HP fraud hotline at 1-877-219-3183. Service or repairs that are required as a result of using non-HP supplies is not covered under HP warranty. Order black cartridge A color print cartridge is low. Order the indicated color print cartridge. Order cyan cartridge Order magenta cartridge Order yellow cartridge Print failure Press OK If error repeats turn The product could not print the current page off then on because of its complexity. PressSetup to clear the message. Allow the product to finish the job, or press Cancel to cancel the job. Scanner error #, Turn off then on The product has experienced an error in the Turn off the power by using the power switch, scanner sub-assembly area. wait at least 30 seconds, and then turn on the power and wait for the product to initialize. If a surge protector is being used, remove it. Plug the product directly into the wall socket. Use the power switch to turn the product on. If the error persists, contact HP. See www.hp.com/support/CM2320series or the support flyer that came in the product box. 206 Chapter 15 Problem solve ENWW