HP Color LaserJet Enterprise CP4525 HP Color LaserJet Enterprise CP4020/CP4520 - Page 207
Install <color> Cartridge, Insufficient Memory To Load
View all HP Color LaserJet Enterprise CP4525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 207 highlights
Table 10-1 Control-panel messages (continued) Description Recommended action INCOMPATIBLE FUSER The incorrect fuser was installed. CAUTION: The fuser can be hot while the product is in use. Wait for the fuser to cool before handling it. 1. Open the right door. 2. Remove the incompatible fuser. 3. Install the correct fuser. 4. Close the right door. INCOMPATIBLE SUPPLIES For status press OK Print cartridges or other supply items are installed that were not designed for this product. The product cannot print with these supplies installed. Press the OK button to identify the incompatible supplies. Install supplies that are designed for this product. INCOMPATIBLE TRANSFER UNIT The incorrect transfer unit was installed. 1. Open right door. 2. Remove the incompatible transfer unit. 3. Install the correct transfer unit. 4. Close the right door. Incorrect The PIN is incorrect. Use the up arrow and down arrow buttons to enter the correct PIN. Initializing The product is starting. No action is necessary. Please wait until the Ready message appears on the display. Initializing permanent storage Displayed when the product is turned on to show that permanent storage is being initialized. No action is necessary. INSTALL CARTRIDGE The print cartridge has been removed or has Replace or reinstall the print cartridge been installed incorrectly. correctly to continue printing. See Replace print cartridges on page 164. INSTALL FUSER The fuser has been removed or installed incorrectly. CAUTION: The fuser can be hot while the product is in use. Wait for the fuser to cool before handling it. 1. Open the right door. 2. Install or adjust the fuser. 3. Close the right door. INSTALL SUPPLIES For status press OK More than one supply is missing or is installed incorrectly. Press the OK button to identify which supplies need to be replaced. Press the OK button a second time for more information about the specific supply. Insert the supply item or make sure the installed supply item is fully seated. INSTALL TRANSFER UNIT The transfer unit has been removed or installed incorrectly. 1. Open right door. 2. Install the transfer unit. 3. Close the right door. INSUFFICIENT MEMORY TO LOAD FONTSDATA The product does not have enough memory To continue without this information, press to load the data (for example, fonts or the OK button . If the message persists, add macros) from the location specified. more memory. ENWW Interpret control-panel messages 193