HP StorageWorks 16-EL SAN Switch 2/16 version 3.1.x - Installation Guide - Page 34
For Rear Rack Access, Attaching the rear rack mount brackets
View all HP StorageWorks 16-EL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Installing the SAN Switch 2/16 For Rear Rack Access Use these steps to attach the rear rack mount brackets to the switch. The rear rack mount brackets act as "stops" to prevent the switch from sliding out the rear of the rack. Use these steps if you installed the inner slide rails to the switch using the procedure outlined in "Attaching the Inner Slide Rails to the Switch," step 1a on page 32. 1. Align the right rack mount bracket with the two screw holes at the port end of the switch. 2. Locate two Phillips head 8-32 x 3/16-inch screws, contained in the Rack Mount Kit. Secure the right mount bracket to the switch, see Figure 5. Figure 5: Attaching the rear rack mount brackets SHR-2490A 3. Tighten the screws and torque to 15-inch pounds. 4. Repeat steps 1 through 3 to install the left mount bracket on the left side of the switch, see Figure 5. 34 SAN Switch 2/16 Version 3.1.x Installation Guide