HP StorageWorks 2/32 SAN switch 2/32 version 4.0.2b release notes - Page 40

Fabric OS Commands errSaveLvlSet Command Short Description: Set error save level of a switch. This command is new for Fabric OS V4.0.2b or higher. Syntax errSaveLvlSet [-s swinst] lvl Availability admin Description Use this command to control types of messages that are saved in the persistent error log. Message types are based on the message severity levels. By default, all messages of type Panic and Critical are saved in the persistent log. If you want to save messages of log levels less severe than Critical, use this command to specify a new message save level. This new message save level is not persistent across a reboot. It is in effect only for that run time cycle. When this command is executed from the Standby CP, the switch instance number operand is required. The switch instance number is supplied by specifying the operand. This operand is not required when logged into the Active CP. Operands This command has the following operands: s swinst - This is an optional parameter. It shows switch instance number. This parameter is required on the Standby CP. This parameter should not be used on the Active CP. You must follow -s with the switch instance number where the command is to be executed. Valid values for switch instance are 0 (for the switch instance associated with slots 1 though 4) or 1 (for the switch instance associated with slots 6 though 10). lvl - Message severity level. Save those error log messages whose message severity level is less than (more severe) or equal to this level. The valid values are: ■ Critical 1 ■ Error 2 ■ Warning 3 ■ Info 4 40 SAN switch 2/32 Version 4.0.2b Release Notes