HP StorageWorks 8/80 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 146

2 cryptoCfg --setEE Sets the encryption routing policy on the local encryption engine to either shared or partitioned. By default the encryption blade is enabled with a "shared dynamic path selection (DPS)" configuration. A slotpoweroff followed by a slotpoweron is required on the encryption blade for the configuration change to take effect. The encryption switch must be rebooted for the change to take effect. In Fabric OSv6.2.0, this command requires root permissions. Routing policy configuration changes persist across switch reboots and power-cycling of the blade, and also survive the CP HA Failover in a chassis or HotCode load on the Encryption switch. slot_number Use cryptocfg --show -localEE to view the routing policy configuration on the local encryption engine. Specifies the slot number of the encryption engine for which to set the routing policy. This operand is required on bladed systems. -routing shared | partitioned Sets the encryption routing policy. When shared is selected,dynamic path selection (DPS) is enabled.When partitioned is selected, static routing is enabled. By default, shared routing is enabled. --enableEE | --disableEE Enables or disables an encryption engine to perform encryption. You must create the encryption group and complete the key vault registration before you can enable an encryption engine for encryption. In addition, you must re-enable the encryption engine for encryption every time a Brocade Encryption Switch or DCX chassis goes through a power cycle event or after issuing slotpoweroff followed by slotpoweron for an FS8-18 blade. This command is valid on all nodes. slot_number Specifies the slot number to identify the encryption engine. This operand is required on bladed systems. --export Exports a certificate from the local encryption switch or blade to a specified external host or to a mounted USB device. This command is valid on all nodes. The files are exported from the predetermined directory that was generated during the node initialization phase. The following operands are supported with the --export command: -scp Exports a specified certificate to an external host using the secure copy (SCP) protocol. When -scp is specified, the following operands are required: host IP | host_name Specifies the IP address of the host to which the file is to be exported. To specify the host by name, it must first be configured with dnsconfig. host_username Specifies the user name for the host. Depending on your host configuration, the command may prompt for a password. 118 Fabric OS Command Reference 53-1001186-01