HP StorageWorks 8/80 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 26

• Error numbers and messages received • supportSave command output • Detailed description of the problem, including the switch or fabric behavior immediately • following the problem, and specific questions • Description of any troubleshooting steps already performed and the results • Serial console and Telnet session logs • syslog message logs 2. Switch Serial Number The switch serial number and corresponding bar code are provided on the serial number label, as shown here: : *FT00X0054E9 FT00X0054E9 The serial number label is located as follows: The serial number label is located as follows: • Brocade 200E -On the non-port side of the chassis. • Brocade 4016-On the top of the switch module • Brocade 4018-On the top of the blade • Brocade 4020 and 4024-On the bottom of the switch module • Brocade 300, 4100, 4900, 5100, 5300, 7500, and Brocade Encryption Switch-On the switch ID pull-out tab located inside the chassis on the port side on the left • Brocade 5000-On the switch ID pull-out tab located on the bottom of the port side of the switch • Brocade 7600-On the bottom of the chassis • Brocade 48000-Inside the chassis next to the power supply bays • Brocade DCX-On the bottom right on the port side of the chassis • DCX-4S-On the port side of the chassis, on the lower right side and directly above the cable management comb. 3. World Wide Name (WWN) Use the wwn command to display the switch WWN. If you cannot use the wwn command because the switch is inoperable, you can get the WWN from the same place as the serial number, except for the Brocade DCX. For the Brocade DCX, access the numbers on the WWN cards by removing the Brocade logo plate at the top of the non-port side of the chassis. Provide the license ID. Use the licenseIDShow command to display the WWN. xxvi Fabric OS Command Reference 53-1001186-01