HP StorageWorks 8/80 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 760

2 SnmpConfig The user name must be between 2 and 32 characters long. The default user names are defined with the noAuth and noPriv protocol. The factory default SNMPv3 user names are: User 1: snmpadmin1 User 2: snmpadmin2 User 3: snmpadmin3 User 4: snmpuser1 User 5: snmpuser2 User 6: snmpuser3 The --default option sets the user name and password to default. If an FCS policy is enabled, the configuration has to be updated on the primary switch and the nonprimary switches; unlike community strings, user names and passwords are not distributed for other switches in the fabric. When new passwords are entered for any user entry, a new authKey and privKey are generated. The new passwords must be updated on the client (e.g., MIB browser) as well. AuthKey and privKey can also be updated with the delta key mechanism provided by the SNMPv3 protocol. The system prompts for password confirmation if a protocol other than NoAuth/NoPriv is selected. Protocol passwords must be between 1 and 20 characters. In order for an SNMP management station to receive SNMPv3 traps generated by the agent, the administrator must configure a trap recipient value to correspond to the IP address of the management station. In addition, the trap recipient must pass the ACL check as described in the Access Control section. The trap recipient must be associated with one of the six users of SNMPv3 and trap severity level. The factory default value for the SNMPv3 trap recipient of each user is 0.0.0.0. Access Control Configuration Parameters The ACL check is as follows: there are six ACLs to restrict SNMP get, set, and trap operations to hosts under a host-subnet-area. The host-subnet-area is defined by comparing nonzero IP octets. For example, an ACL of 192.168.64.0 enables access by any hosts that start with the specified octets. The connecting host is enabled to set each host-subnet-area to be read-write or read-only. The closest match out of six entries is given access. The ACL check is turned off when all six entries contain 0.0.0.0. The default values of all six entries are 0.0.0.0. For IPv6 subnets, the format is specified by an IPv6 address followed by the number of fixed bits in the address. MIB Capability Configuration Parameters The mibCapability option turns certain MIBS and TRAPS on or off. If SNMP MIB is disabled, then corresponding traps also are disabled. If any trap group is disabled, the corresponding individual traps also are disabled. FA-MIB Specifying yes means you can access FA-MIB variables with an SNMP manager. The default value is yes. FICON-MIB Specifying yes means you can access FICON-MIB variables with an SNMP manager. The default value is yes. HA-MIB Specifying yes means you can access Entity-MIB and HA-MIB variables with an SNMP manager. The default value is yes. 732 Fabric OS Command Reference 53-1001186-01