HP StorageWorks 8/80 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 167

cryptoCfg 2 Notes Operands • Host NWWN • Host PID • VI WWN • VT NWWN • VT PID • LUN number • Tape session number • For each Tape session: - Number of uncompressed blocks - Number of compressed blocks - Number of uncompressed bytes - Number of compressed bytes Encryption groups and HA clusters must be configured before performing any CryptoTarget container and Crypto LUN configurations. When adding a LUN to a CryptoTarget container, special attention should be paid to the input format. A LUN number can be entered either as a 16-bit (2 bytes) number in hex notation (for example, 0x07) or as a 64-bit (8 bytes) number in WWN format (for example, 00:07:00:00:00:00:00:00). Although the command does accept decimal input, it is not recommended. The conversion function used to parse the LUN number converts a decimal number beginning with 0 to an octal, which results in a conversion error. For example, 035 is interpreted as 29 (decimal), or 0x1D hex, or 00:1D:00:00:00:00:00:00. To ensure correct conversion to decimal notation, use the recommended Hex formats or make sure to remove preceding zeros from decimal input. The cryptoCfg storage device configuration and management function has the following operands: --help -devicecfg Displays the synopsis for the storage device configuration and management function. This command is valid on all nodes. --create -container Creates a CryptoTarget container (CTC) for a disk or a tape storage device. The target device port WWN must be specified and one or more initiator port WWNs (PWWNs) may optionally be specified. Additional initiator PWWNs may be added after the CryptoTarget container is created. Upon commit of a CTC configuration, one virtual target (VT) is created, and for each initiator that has the access to the target port, one virtual initiator (VI) is created. These virtual devices are created by logging into the fabric and registering with the Name Server. Initiator and target must be zoned for NS-based frame redirection to take effect. Use nsshow to verify the creation of the virtual devices. Use cfgshow to view the redirection zone. This command is valid only on the group leader. The following operands are supported: disk | tape Specifies the type of the CTC as a disk array or tape storage container depending on the target device. These operands are mutually exclusive. Fabric OS Command Reference 139 53-1001186-01