HP StorageWorks 8/80 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 394
FC IPv4 address from a logical switch. On a switch that is not in Virtual, Fabric mode, use - 800 numbers
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 394 highlights
2 ipAddrSet -slot number On a chassis with a blade processor (BP), specifies the slot number. On standalone platforms with a hidden BP, such as the AP76500, this parameter is not accepted. -ipv6 [-auto | -noauto] Enables or disables stateless IPv6 auto configuration on a switch or chassis. When auto configuration is enabled, the host automatically performs configuration of IPv6 addresses and periodic non-disruptive re-configuration. By default, auto configuration is disabled. -ls FID Specifies the logical fabric ID for which to configure an IPFC network interface. The FID is a decimal number. A switch that is not in Virtual Fabric mode uses the -ls parameter with FID 128 (the effective, single Logical Fabric number on such switches) to set the IPv4 FC address. --add Assigns a specified IPv4 FC address and prefix to the logical switch instance represented by the specified FID. This command replaces any existing FC IPv4 address. IPv4_address/prefix Specifies the IPv4 address and prefix for the IPFC network interface. The IP Address is represented by a dotted decimal number, followed by a slash and a prefix. This operand is required with the --add option. --delete -ls IFID Deletes the IPv4 FC address and prefix from a logical switch. Specifies the fabric ID that identifies the logical switch for which to delete the FC IPv4 address and prefix. This operand is required when deleting a FC IPv4 address from a logical switch. On a switch that is not in Virtual Fabric mode, use the -ls parameter with FID 128 (the effective, single Logical Fabric number on such switches) to delete the IPv4 FC address. When used interactively to configure IPv4 addresses on a modular platform, ipAddrSet prompts for the following parameters: -cp cp_number Specifies the managed entity as a CP. Valid values are: 0 Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address, and host name of CP0. 1 Sets the Ethernet IP address, Ethernet subnet mask, gateway IP address, and host name of CP1. -chassis Specifies the managed entity as the chassis. Examples Command line examples To configure an IPv6 address and prefix on a standalone platform: switch:admin> ipaddrset -ipv6 --add fec0:60:69bc:60:260:69ff:fed0:107/64 To configure an IPv6 address and prefix on a single CP of a chassis: switch:admin> ipaddrset -cp 0 -ipv6 --add 1080::8:800:200C:417A/64 To delete any existing IPv6 address and prefix on CP0 on an enterprise-class platform: switch:admin> ipaddrset cp 0 -ipv6 --delete 366 Fabric OS Command Reference 53-1001186-01