HP StorageWorks 8/80 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 572

2 portCfg dest_IPv6_addr/prefix_len Specifies the destination IPv6 address of the virtual port, if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. This is used for IPv6 addresses instead of a netmask. The prefix_len operand is required. dest_IPv4_addr netmask Specifies the destination IPv4 address of the virtual port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well. Use a.b.c.d. format. gateway_router Specifies the IP address of an IP router that can route packets to the destination virtual port IP address. The gateway address must be on the same IP subnet as one of the port IP addresses. This operand is optional with IPv6 addresses. If not specified, the gateway_router learned from the Neighbor Discovery protocol is used. metric Specifies the link metric associated with the route. Valid values are 0-255. The default value is 0. A low value encourages the use of the route, and a high value discourages the use of a route. delete ipaddr Deletes IP routes for specified IPv4 or IPv6 address. ipaddr Specifies IP address in either IPv6 or IPv4 format: IPv6_addr/prefix_len Specifies the IPv6 address of the virtual port, if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. The prefix_len operand is required. dest_IPv4_addr netmask Specifies the destination IPv4 address of the virtual port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well. Use a.b.c.d. format. rscnsupr -range --disable --enable Manages Registered State Change Notification (RSCN) suppression on the local port. RSCN suppression is configurable for both FC and GbE ports; however, configuration options are dependent on the protocol. The syntax for portCfg rscnsupr is as follows: portcfg rscnsupr [slot/][ge]port [-range] mode The following operands are supported with the rscnsupr option: Specifies a range of ports in the same slot to which to apply the configuration. This operand is optional. Valid modes for rscnsupr are: Disables the configuration. When disabled, device changes on the port generate an RSCN to another end device that is zoned with this one. By default, RSCN suppression is disabled on all ports. Enables the configuration. When enabled, any device changes on the port will not generate an RSCN to any other end device. 544 Fabric OS Command Reference 53-1001186-01