HP StorageWorks 8/80 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 571

portCfg 2 -P l2cos Specifies the L2 Class Of Service (COS) Tagging value. Use the portShow fciptunnel geport all -qosmap command to display current values. Supported range is 0-7. ipif Defines the IP interface for both ports of a tunnel. Up to eight IP interfaces per GbE port are supported. The IP network connection between two 7500 routers or two FC4-18i blades is configured by defining IP interfaces for origin and destination virtual ports, and then defining one or more IP routes to connect them. IPv6 addresses are supported on switches running v6.0 or later. The syntax for portCfg ipif is as follows: portcfg ipif [slot/][ge]port option arguments Valid options and arguments for ipif are: create src_ipaddr mtu_size Creates IP interfaces. Specify the following: src_ipaddr Specifies source IP address in either IPv6 or IPv4 format: src_IPv6_addr/prefix_len Specifies the source IPv6 address of the virtual port if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. This is used for IPv6 addresses instead of a netmask. The prefix_len operator is required. src_IPv4_addr netmask Specifies the source IPv4 address of the virtual port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well (in a.b.c.d. format.) mtu_size Specifies the maximum transmission unit size. The range allowed is 1260 to 2348 KB. This operand is required. delete ipaddr Deletes IP interfaces. Specify the IPv6 or IPv4 address of the virtual port. iproute Defines static IP routes on a GbE port. After defining the IP interface of the remote switch, you can define destination routes for an interface. A maximum of 40 routes per GbE port are supported. IPv6 addresses are supported on platforms running v6.0.0 or later. You cannot use this command to configure routes for inband management; use portCfg inbandmgmt instead. The syntax for portcfg iproute is as follows: portcfg iproute [slot/][ge]port option arguments Valid options and arguments for iproute are: create dest_ipaddr [gateway_router] metric Creates IP routes, where: dest_ipaddr Specifies the destination IP address in either IPv6 or IPv4 format: Fabric OS Command Reference 543 53-1001186-01