HP StorageWorks 8/80 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 608

2 portCfgShow Port Auto Disable Displays On when the Auto Disable feature is enabled on a port or (..)/OFF when disabled. This feature causes ports to become disabled when they encounter an event that would cause them to reinitialize. This feature is enabled by the portCfgAutoDisable command. The feature is disabled by default. Notes The output of this command may vary depending on the hardware platform and port type. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command supports the following port options: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). [ge]port Specifies the number of the port to be configured, relative to its slot for bladed systems. For GigE ports, the ports are numbered ge0 - ge1. Use the switchShow command for a list of valid ports. Use portCfgshow with one of the following options and optional arguments to display specific FCIP-related parameters configured for a gigabit Ethernet port: arp Displays the address resolution protocol (ARP) table. ipif Displays the IP interface for both ports of the tunnel. IPv6 addresses are supported. iproute Displays the IP route on the specified GbE port. IPv6 addresses are supported. mode Displays the mode of the specified GbE port. FCIP or not configured. vlantag Displays VLAN Tagging configuration. fciptunnel all | tunnel_id Displays FCIP tunnels on the specified GbE port. Valid arguments for fciptunnel include. Display includes all FCIP tunnels on the port or the specified FCIP tunnel only. Valid values for tunnel_id are 0-7. -ipsec Displays IKE and IPSec policy information on IPSec-enabled tunnels. This argument is optional. -qosmap Displays the VC to QoS mapping. This argument is optional. inbandmgmt Displays any inband management interfaces configured on the 7500 for a specified GbE port. Examples To display the port configuration settings on an enterprise-class platform: switch:admin> portcfgshow Ports of Slot 2 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Speed AN AN AN AN AN AN AN AN AN AN AN AN AN AN AN AN AL_PA Offset 13 Trunk Port ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON Long Distance VC Link Init 580 Fabric OS Command Reference 53-1001186-01