HP StorageWorks 8/80 Brocade Fabric OS Command Reference Manual v6.2.0 (53-100 - Page 568

2 portCfg both a DSCP and L2CoS value. These default values can be modified on a per-FCIP tunnel basis with the fciptunnel qosmap option. The -M option can be turned on or off any time. Qosmap settings are unaffected by the -M option. -m time Specifies the minimum retransmit time, in milliseconds. The range is 20 to 5,000; the default is 100. -n remote_wwn Specifies the remote-side FC entity WWN. -q control-dscp Specifies the DSCP (DiffServ Code Point) Marking used for control TCP connection of the FCIP tunnel. This operand is optional. Range is 0 to 63 (inclusive). Default value is 0. -Q data-dscp Specifies the DSCP (DiffServ Code Point) Markingused for data TCP connection of the FCIP tunnel. This operand is optional. Range is 0 to 63 (inclusive). Default value is 0. -r retransmissions Specifies the maximum retransmissions. Values are 1 to 16; default is 8. If Tape Piplelining is enabled, the default value is calculated based on the minimum retransmit time to ensure that the TCP connection does not time out before the host times out. The specified value must be greater than the calculated value. -s Disables selective acknowledgement code (SACK) on the specified tunnel. -t Enable read/write Tape Piplelining on the tunnel specified (requires Fastwrite to be turned on as well). -ike policy Specifies the Internet Key Exchange (IKE) policy number to be used on the specified tunnel. This option must be used together with -ipsec and -key. -ipsec policy Specifies the Internet Protocol security (IPSec) policy number to be used on the specified tunnel. This option must be used together with -ike and -key. -key preshared-key Specifies the preshared key to be used during IKE authentication. Specify a double quoted string of alphanumeric characters between 12 and 32 bytes in length. This argument must be used together with -ike and -ipsec. -v vlan_id NOTE: Only a single IPSec-enabled tunnel can be configured on a port. No other tunnels (IPSec or otherwise) can be configured on the same port. Jumbo frames are not supported on secure tunnels. Only a single route is supported on an interface with a secure tunnel. Creates an FCIP tunnel with VLAN Tagging and Class of Service (CoS). Specify a vlan_id in the range between 1 and 4094. There is no default. If any other VLAN option is specified, this must also be specified. The following operands are optional with VLAN tagging: 540 Fabric OS Command Reference 53-1001186-01