HP StorageWorks 8/80 HP StorageWorks 8Gb SAN Switch hardware reference manual - Page 31
Table 8 SAN Switch Rack Mount Kit hardware, shown
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
The following items are required to install the switch in a rack: • SAN Switch or MP Router • Power cables • #2 Phillips screwdriver • 7/16-inch wrench or socket • Plenum (if required). For 8Gb models, a plenum is required for 8/8 and 8/24 SAN Switches only. • SAN Switch Rack Mount Kit hardware, shown in Table 8, which identifies rails and rail mounting hardware Table 8 SAN Switch Rack Mount Kit hardware Item Description Two rear mounting brackets A right inner rail and a right outer rail A left inner rail and a left outer rail 14 #8-32 x 3/16-inch Phillips pan-head screws with thread lock for use with the SAN Switch 2/32 only. 14 #8-32 x 5/16-inch Phillips pan-head SEMS screws 10 #10-32 x 1/2-inch Phillips pan-head screws with captive star lock-washers Eight #10 alignment washers Eight #10 adapter washers Two 1/4-20 hex nuts with captive star lock-washers Two 1/4-inch flat washers CAUTION: For proper air flow, the SFP media side of the SAN Switch must face the rear of the rack. This mounting allows air to enter the front of the rack and exhaust at the rear. 8Gb SAN Switch hardware reference manual 31