HP StorageWorks 8/80 HP StorageWorks 8Gb SAN Switch hardware reference manual - Page 32
Installing the rear mounting brackets HP 10000 series racks, Table 8,
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
To install the device in a rack: 1. Verify that the required parts and hardware are available. See Table 8. 2. Choose a mounting location for the device in the rack. 3. Attach the rear mounting brackets to the rear rack uprights: • For HP 10000 series racks, assemble each of the two brackets with two #10-32 x 1/2-inch Phillips pan-head screws with captive star lock-washers and two #10 adapter washers, as shown in Figure 8. • For an HP System/e Rack, install the two rear mounting brackets with two #10-32 x 1/2-inch Phillips pan-head screws and two #10 alignment washers, as shown in Figure 9. Figure 8 Installing the rear mounting brackets (HP 10000 series racks) Figure 9 Installing the rear mounting brackets (HP System/e Rack) NOTE: Your SAN Switch Rack Mount Kit contains both right rails and left rails. The rails are labelled Right and Left. 32 Installing and configuring an 8Gb SAN Switch