HP Superdome SX2000 Installation Guide, Sixth Edition - HP Integrity Superdome - Page 27

Removing Protective Cardboard from the Housing

Get HP Superdome SX2000 PDF manuals and user guides View all HP Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

2. Remove the cardboard from the blower housing (Figure 1-13). This cardboard protects the housing baffle during shipping. If it is not removed, the fans can not work properly. Figure 1-13 Removing Protective Cardboard from the Housing NOTE: Double-check that the protective cardboard has been removed. 3. Using the handles on the housing labeled Blower 3 Blower 2, align the edge of the housing over the edge at the top rear of the cabinet, and slide it into place until the connectors at the back of each housing are fully mated (Figure 1-14). Then tighten the thumbscrews at the front of the housing. Figure 1-14 Installing the Rear Blower Housing Setting Up the System 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
2.
Remove the cardboard from the blower housing (
Figure 1-13
).
This cardboard protects the housing baffle during shipping. If it is not removed, the fans
can not work properly.
Figure 1-13 Removing Protective Cardboard from the Housing
NOTE:
Double-check that the protective cardboard has been removed.
3.
Using the handles on the housing labeled
Blower 3 Blower 2
, align the edge of the housing
over the edge at the top rear of the cabinet, and slide it into place until the connectors at the
back of each housing are fully mated (
Figure 1-14
). Then tighten the thumbscrews at the
front of the housing.
Figure 1-14 Installing the Rear Blower Housing
Setting Up the System
27