HP Visualize J5000 hp Visualize J5000, J7000 workstations parts removal and re - Page 12
Top, Front, and Side Panels
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Parts Removal and Replacement Top, Front, and Side Panels Top, Front, and Side Panels This section describes how to remove and replace the top, front, and side panels. Removing the Front Panel 1. Power down your workstation as described in "Getting Started." If locked, unlock the door on the front of the system and swing it to the right (see Step 1 in the figure below). 2. Once the door is open, unscrew the two panel-detach screws in the top and bottom corners of the right edge of the panel. These screws are visible when the door is open. 3. Swing the entire front panel 45 to 90 to the left (Step 3 in the figure below). 4. Pull the panel straight out to remove it (Step 4 in the figure below). Set the panel and its screws aside. Figure 2-1. Removing the Front Panel 4 1 3 4 T-1T5 12 Chapter 2