HP Visualize J5000 hp Visualize J5000, J7000 workstations parts removal and re - Page 25
Replacing the Flex Cable and Flex Cable Retainer
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Parts Removal and Replacement Removing and Replacing the Flex Cable Retainer and Cable Replacing the Flex Cable and Flex Cable Retainer Figure 2-17. Attaching the Flex Cable Squeeze handles together Flex cable retainer 1. Set the flex cable on top of the divider that separates the system board from the I/O board. 2. Align the flex cable connectors with the connectors of the I/O board. Press firmly to seat the connectors. It requires considerable pressure to fully seat the connectors. Carefully inspect the connection to ensure that the connectors are fully seated. 3. Repeat step 2 for the system board side of the flex cable. NOTE The flex cable and connectors are symmetrical and can be installed in either orientation. 4. Fit the cable retainer over the flex cable. The retainer should fit snugly against the flex cable with the ejector handles fitting into the four slots in the retainer. If the retainer does not slip over the flex cable, the flex cable is not connected properly. Chapter 2 25