HP Visualize J5000 hp Visualize J5000, J7000 workstations parts removal and re - Page 19
Power Supply
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Parts Removal and Replacement Power Supply Power Supply This section describes how to remove and replace the Power Supply. NOTE Prior to removing the Power Supply, the Top, Front, and Side Panels need to be removed. Refer to the appropriate section(s) for the steps to remove and replace these components. 1. Facing the power supply, remove the PCI retainer clip by pressing down on the top of the clip and pulling it out (see Step 1 below). Figure 2-8. Removing the Power Supply, Steps 1-3 Step 1: Remove PCI Retainer Clip Step 2: Remove Busbar Shield Step 3: Remove Busbar Screws 2. Remove the bus bar shield by pulling outward on its latch, and then lifting it up (Step 2 above). This shield can be used to hold the screws you will remove in the next step. 3. Remove the four T-15 Torx thumbscrews (five screws if it's a J7000) from the power supply bus bars (Step 3 above). The bus bar screws are longer than the other T-15 Torx screws. Chapter 2 19