HP Visualize J5000 hp Visualize J5000, J7000 workstations parts removal and re - Page 42

Replacing the Front-Panel Display

Page 42 highlights

Parts Removal and Replacement Replacing the Front-Panel Display Replacing the Front-Panel Display 1. Connect the chassis hooks on the left side of the front-panel display with the corresponding slots on the chassis. Figure 2-39. Front Panel Display Hooks 25-pin Connector Front-Panel Display Hooks Power Switch Front-Panel Display 2. Squeeze the right side tab while rotating the assembly to the right. Release the tab when the assembly is flush with the chassis; the front-panel display will snap into place. Figure 2-40. Front Panel Display T-15 Torx Screw Power Switch 25-pin Connector T-15 Torx Screw Front-Panel Display Release Tab 3. Plug the ribbon cable's 25-pin connector into its socket and secure it with the two T-15 Torx screws. 42 Chapter 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

42
Chapter 2
Parts Removal and Replacement
Replacing the Front-Panel Display
Replacing the Front-Panel Display
1.
Connect the chassis hooks on the left side of the front-panel display with the
corresponding slots on the chassis.
Figure 2-39. Front Panel Display Hooks
2.
Squeeze the right side tab while rotating the assembly to the right. Release the tab
when the assembly is flush with the chassis; the front-panel display will snap into
place.
Figure 2-40. Front Panel Display
3. Plug the ribbon cable’s 25-pin connector into its socket and secure it with the two T-15
Torx screws.
Front-Panel Display Hooks
Power Switch
25-pin Connector
Front-Panel Display
T-15 Torx Screw
Release Tab
Front-Panel
T-15 Torx Screw
Power Switch
25-pin Connector
Display