HP Visualize J5000 hp Visualize J5000, J7000 workstations parts removal and re - Page 26
Removing and Replacing the System Board
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Parts Removal and Replacement Removing and Replacing the System Board Removing and Replacing the System Board This section describes how to remove and replace the system board. NOTE Prior to removing the System Board, the Front, Top, Right Side Panel, the Flex Cable, and DIMMs need to be removed. See the appropriate section(s) for removing and these components. To avoid system damage, make sure your static-grounding strap is securely attached to your wrist and to the bare metal on the workstation. Removing the Bus Bar Shield 1. Remove the bus bar shield by pulling outward on its latch, and then lifting it up. Figure 2-18. Removing the Bus Bar Shield Step 1: Remove Bus bar Shield Step 2: Remove Bus bar Screws 2. Remove the four T-15 Torx (five on the J7000) thumbscrews from the power supply bus bar. The bus bar screws are longer than the other T-15 Torx screws. Removing the System Board 1. Ensure all workstation cables are out of the way to avoid interference or damage when you remove the system board tray. 26 Chapter 2