HP Visualize J5000 hp Visualize J5000, J7000 workstations parts removal and re - Page 18
Replacing the Memory Cards DIMMs
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Parts Removal and Replacement Memory Card(s) DIMMS Figure 2-7. Removing a DIMM Ejector Tab Ejector Tab 2. Grasp the memory card by its edges and lift it straight out. Place the card on the conductive sheeting. 3. Repeat steps 1 and 2 for all memory cards. Replacing the Memory Card(s) (DIMMs) 1. Refer to the label in the system for correct installation sequence. 2. Make sure the ejector tabs are angled outward. Align the notched edge of the memory card with its slot. Insert the memory card and firmly and evenly push down on each side to lock it into place. The ejector tabs will angle upward. 3. Visually inspect and confirm the connection between the memory card and the system board. 4. Repeat steps 1 and 2 for all memory cards. 5. Replace the Front Air Guides and Support Bars. 18 Chapter 2