IBM 867431X Hardware Maintenance Manual - Page 122
Diskette/CD-ROM drive bracket
View all IBM 867431X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Diskette/CD-ROM drive bracket Slim adapter board Diskette drive retaining wire Metal tab Diskette drive Bracket CD-ROM drive retaining wire CD-ROM drive To remove the diskette/CD-ROM drive bracket: Note: Read"Safety information" on page 147 and "Before you begin" on page 45. 1. Remove the diskette/CD-ROM drive. See "Diskette/CD-ROM drives" on page 113. 2. Remove the diskette drive: a. Remove the diskette drive retaining wire by releasing it from the metal tab and removing it from the holes, and put it in a safe place. b. Lift the diskette drive up on one side until it will separates from the bracket. c. Diskette drive cable: 1) The diskette drive cable is removed by gently pulling the cable up until it is released from the connector. 2) To replace the diskette drive cable, pull up on the connector latch until it is unlocked; then, insert the end of the cable into the connector and gently push down on the connector latch until it clicks into place. 3. Remove the CD-ROM drive: a. Remove the CD-ROM drive retaining wire by releasing it from the metal tab and removing it from the holes, and put it in a safe place. b. Gently loosen the connector of the slim adapter board from the CD-ROM drive connector until it pulls free; slide the slim adapter board down until it clears the notches on the bracket and remove it. c. Slide the bracket toward the rear and remove it. 114 Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building System Type 8674